BASEMENT TILE INSTALLATIONS

Tiling a basement can be a great way to add a durable and low-maintenance flooring option to your home. However, before you start tiling, it's important to make sure your basement is suitable for this type of flooring. Basements are prone to moisture and water damage, so it's important to make sure the concrete slab is dry and free from any cracks or damage. If there are any issues with the concrete, they should be repaired before tiling. Once the concrete is prepared, you can start tiling. The first step is to apply a moisture barrier to the concrete. This can be a paint-on product or a roll-on product, and it will help to prevent any moisture from seeping up into the tiles.

Next, you'll need to apply a layer of thinset mortar to the concrete. This is the adhesive that will hold the tiles in place. Use a notched trowel to spread the mortar evenly across the concrete. Then, lay the tiles in the desired pattern, using tile spacers to ensure even spacing between each tile. Use a tile cutter to cut tiles to fit around the edges of the room or around any obstacles. Once the tiles are laid, allow the thinset to dry completely, usually for at least 24 hours. Then, apply grout to the joints between the tiles, using a grout float to push the grout into the joints. Finally, use a damp sponge to wipe away any excess grout and allow the grout to dry completely. Once the grout is dry, the tiles are ready for use.

Making a basement floor level is an important step when preparing to install new flooring. Here are the steps to follow when making a basement floor level:
Consider the Drypack method for best results, Or the secondary method below, (we Recommend Drypack - Always)

Determine the high and low spots:
Use a level to determine the high and low spots on the basement floor. Mark these spots with a pencil or masking tape.

Remove any high spots:
Use a concrete grinder or chisel to remove any high spots on the floor. This will help to create a level surface.

Fill any low spots:
Use a self-leveling compound to fill any low spots on the floor. This compound is a liquid that will fill in any dips or valleys in the floor and level it out.

Mix the self-leveling compound:
Follow the manufacturer's instructions to mix the self-leveling compound. This will typically involve mixing the compound with water and stirring until it is smooth.

Pour the self-leveling compound:
Pour the self-leveling compound onto the low spots on the floor. Use a trowel or screed to spread the compound evenly over the surface of the floor.

Allow the self-leveling compound to dry: The self-leveling compound will typically dry within a few hours. Check the manufacturer's instructions for the recommended drying time.

Sand or grind any high spots:
Once the self-leveling compound is dry, use a concrete grinder or sander to smooth out any high spots on the floor.

Clean the floor:
Sweep or vacuum the floor to remove any dust or debris.

Once the basement floor is level, you can proceed with installing you’re the tile.

For a professional tile installer, call Precision Marble and Tile for Basement tile installation service in :
Ajax, Alliston, Aurora, Ballantrae, Barrie, Bolton, Bradford, Brampton, Concord, Durham, East Gwillimbury, Guelph, Georgina, GTA, Hamilton, Innisfil, Keswick, King City, Maple, Markham, Mount, Albert, Newmarket, Niagara Falls, Nobleton, North York, Orangeville, Orillia, Oshawa, Pickering,Port Perry, Queensville, Richmond Hill,, Sharon, Schomberg, Simcoe, Stouffville, Sutton, Toronto, Tottenham, Uxbridge, Vaughan, Waterloo, Whitby, Woodbridge and other surrounding areas.

Copyright @ 2023 Precision Marble And Tile. All rights reserved.